Software/axiom

Version 1.04 RC

New features

• Can backup DCS log on external thumb drive.
• Can send DCS log over Internet.
• If clear Job number machine than use internal tool and prism index.
• Automatically save/restore config files using FingerPrint and DiskOnModule.
• Check machine parameters and job data are valid before starting a cycle.
• Multi-languages implemented.
• Can use or ignore OMA block data.
• Checks block data before starting a cycle.

Bugs fixed

• Bug#438 After pulling up a new job the screen switch to the Lens screen.
• Bug#186 Not a bug.
• Bug#192 Need red message when an error occurs.
• Bug#019 Can change serial port speed.
• Bug#189 USB driver crash (not fixed: use new thumb drive)
• Bug#438 Go to lens screen after downloading a job.
• Bug#422 Use IFRNT if valid; if else use FRNT.
• Bug#007 Use tool index and prism index to generate lens curve.

Download

• Axiom USB software update (download)
• Axiom finger print generator (download)

Version 1.04.08 beta

Bugs fixed

• Passe size
• PT update time changed from 60 to 15
• New tangent algorithm
• New PID values
• Chuck protection reduce for lenses
• Calibration Wizard requires better precision on lens curve
• Internet server IP address updated.
• Bug#563: Sag gauge range
• Bug#615: Label "base curve" replaced by "sag value"
• Bug#009: Cutter algorithm position error for high curve
• Bug#262: We need to be able to cut wax
• Bug#271: When cutting flat curves (near plano) a lip can be present around the outer edge of the lens
• Bug#567: Laps with high cylinder are showing flat and with propellar marks
• Bug#582: The pin bevel applied is not flat and is inconsistent
• Bug#585: Surface finish on laps not comparable to 2G
• Bug#614: One lens job screen, base,cross and back curve are by default negative.
• Bug#287: Lap calibration use it own cycle speed

Download

• Axiom USB software update (download)
• Axiom finger print generator (download)

Related link

• Axiom manuals and technical information